Before installation,clean the shaft journal and housing.Ensure no burrs,iron fillings,oil or dirt and other foreign matter.
Do not directly strike the outer ring or inner ring of the bearing.Do not strik it violently.Use special tools to mount it uniformly to prevent internal damage of the bearing.
Oil bath,electricinduction heating or constant temperature furnance are recommented to use in order to get the even heating.Partially overheating should be avoided.Flame for baking is forbidden.The temperature should be in the reasonable range.The heating of the bearing can not exceed 120℃.Bearings with seals or dust covers are should not to exceed 80°c to
prevent lubricating oil failure or seal deformation.
After installation is completed, check the clearance and coaxiality. Ensuresmooth rotation without sticking or abnormal noise.
Maintain a clean installation environment, Avoid dust and debris fromentering the bearing interior to affect its lifespan.
Filling lubricate grease / oil according to the bearing model. Add suitable grease to avoid overheating and burning damage of bearing
Measurement and assembly should be under the same temperature to reduce the influence of thermal expansion and contraction.
Note: The bearings should be stored in a dry, cool and ventilated place,keeping the original packaging undamaged. They must be protected from moisture, dust and excessive pressure. Before installation, clean the shaft and housing. Do not use violent impact or open flame heating. Perform clean work, apply uniform pressure, and check if the rotation is smooth.Reasonably lubrication flling to extend the service life.